Blower motor replacement
Replacement of the indoor air-handler blower motor (multi-speed PSC or variable-speed/constant-torque ECM), including capacitor or module checks, wheel alignment, and airflow verification.
Florida DBPR licences CAC1824292 · RA13067646 · 277 W 26th St, Hialeah
Warning signs & symptoms
If you notice any of these symptoms on your air-conditioning equipment in Hialeah, note them before calling (786) 303-3739.
- Outdoor unit is running and copper line is cold/frosted, but zero air is blowing from indoor ceiling or wall vents.
- Loud screeching, grinding, or metallic squeal from the air-handler closet when the fan starts.
- ECM blower motor rocks back and forth or pulses on and off without reaching full speed.
- Hot electrical smell near the air handler accompanied by the motor tripping its internal thermal protector.
Technical scope & inspection procedure
What a licensed air-conditioning contractor checks and performs during this service.
-
01
Verify 24V fan relay/control board signal and line voltage at the motor before condemning the motor.
-
02
Pull the blower assembly, release the squirrel-cage wheel from the shaft, and inspect the wheel and housing.
-
03
Mount the matched replacement blower motor (and new run capacitor for PSC motors), align the wheel, and balance clearance.
-
04
Set proper cooling/heating speed taps, verify amp draw against nameplate FLA, and test duct airflow.
When targeted repair or service is the right call
A PSC blower motor fails to start solely because of a failed indoor run capacitor or a loose fan relay wire on the control board.
When component or system replacement is needed
Motor shaft bearings have play or drag, windings are open or shorted, or the ECM motor's integrated electronic module has failed.
Technical questions & answers
What is the difference between a PSC blower motor and an ECM blower motor?
A PSC (Permanent Split Capacitor) motor uses an external run capacitor and fixed speed wires. An ECM (Electronically Commutated Motor) uses an onboard microprocessor module to maintain constant torque or variable airflow.
Should I turn the AC off if the indoor blower stops blowing air?
Yes, turn the thermostat to OFF immediately. Running the outdoor compressor without the indoor blower fan will freeze the evaporator coil solid and can damage the compressor.
Why is the blower wheel inspected when replacing the blower motor?
A clogged or unbalanced blower wheel often overloaded the original motor bearings in the first place. Ensuring the wheel is clean and true protects the new motor.
Request a quote
Call (786) 303-3739 or use the visual demo form below. No prices are published online.