SVC-12 Electrical & Controls

thermostat replacement

Testing of the 24-volt control circuit and replacement of the wall thermostat (listed as thermostat replacement on wynwoodac.com), configuring system type (straight cool vs. heat pump), C-wire power, and compressor short-cycle protection.

Florida DBPR licences CAC1824292 · RA13067646 · 277 W 26th St, Hialeah

Warning signs & symptoms

If you notice any of these symptoms on your air-conditioning equipment in Hialeah, note them before calling (786) 303-3739.

  • Thermostat screen is unresponsive or blank even with fresh batteries (or when powered by the 24V C-wire).
  • Setting the thermostat to Cool makes an audible click on the wall, but neither the indoor fan nor outdoor unit starts.
  • Displayed room temperature is several degrees off from an independent thermometer, causing overcooling or warm rooms.
  • Improperly configured thermostat after a DIY swap blows warm air (heat pump O/B reversing valve setting inverted).

Technical scope & inspection procedure

What a licensed air-conditioning contractor checks and performs during this service.

  1. 01

    Test 24V AC transformer voltage between R and C at the wall subbase and verify float switch continuity before replacing the thermostat.

  2. 02

    Label and inspect low-voltage control wires (R, C, Y, G, W / O-B) for nicked insulation or loose splices.

  3. 03

    Mount the replacement thermostat level on the wall, configure equipment staging (heat pump reversing valve vs. electric strip heat), and enable compressor delay protection.

  4. 04

    Test cooling call (Y + G), fan control, and temperature calibration.

When targeted repair or service is the right call

The thermostat is blank only because a clogged drain tripped the float safety switch or a loose low-voltage wire disconnected R/C power.

When component or system replacement is needed

Internal relay contacts on the thermostat board fail to close Y or G outputs, the thermistor sensor is out of calibration, or the display is damaged.

Technical questions & answers

Why did my thermostat go blank when nothing is wrong with the thermostat itself?

Hardwired thermostats get their 24-volt power from the indoor air handler. If the condensate drain line clogs, the safety float switch cuts that 24-volt wire, turning the thermostat screen off to alert you.

Why does system configuration (Straight Cool vs. Heat Pump) matter on a replacement thermostat?

In South Florida, some systems use a heat pump reversing valve (O/B terminal) while others use straight cool with electric heat strips (W terminal). The wrong installer setting can energize heat strips during cooling.

What is the 5-minute compressor time delay in a thermostat?

It prevents the outdoor compressor from restarting immediately after a brief power flicker or rapid thermostat adjustment, allowing refrigerant pressures to equalize first.

Request a quote

Call (786) 303-3739 or use the visual demo form below. No prices are published online.

Demo only: nothing is sent.